Gray-Scott Model at F 0.1100, k 0.0530
These images and movie demonstrate the behavior of the Gray-Scott reaction-diffusion system with σ=Du/Dv=2 and parameters F=0.1100, k=0.0530.
Red spots on blue grow into "bubbles" whose boundaries have surface tension. Smaller bubbles (which tend to have a smaller number of edges) shrink while larger bubbles (with a greater number of edges) grow, until a hexagonal pattern is reached. A similar phenomenon is seen in negative to the west.
Surface tension is notably less here than to the immediate east, and the bubbles coalesce more slowly.
Categories: Munafo ρ; Wolfram 2-a (glossary of terms)
decrease k |
|
15 frames/sec.; each fr. is 1001 iter. steps = 500.5 tu; 1801 fr. total (901,400 tu) | increase k |
decrease F |
In these images:
- Color indicates level of u, ranging from purple (lowest u values) through blue, aqua, green, yellow and pink/red (highest u values)
- Areas where u is increasing are lightened to a light pastel tone; where u is decreasing the color is vivid.
- In areas where u is changing by less than ±3×10-6 per tu, an intermediate pastel color is seen. This includes areas that are in steady state or equilibrium.
''tu'' is the dimensionless unit of time, and ''lu'' the dimensionless unit of length, implicit in the equations that define the reaction-diffusion model. The grids for these simulations use Δx=1/143 lu and Δt=1/2 tu; the system is 3.2 lu wide. The simulation meets itself at the edges (periodic boundary condition); all images tile seamlessly if used as wallpaper.
Go back to Gray-Scott pattern index
This page was written in the "embarrassingly readable" markup language RHTF, and was last updated on 2019 Jan 05. s.11